To ensure the best result for your quilt, please follow these guidelines:
Quilt top, backing, and batting are in 3 separate pieces
Do not pin or baste the quilt top, backing and batting together. These are loaded onto the longarm machine separately. Each layer is centered when it is attached to the machine, but it is impossible to exactly center the quilt vertically and horizontally with the backing. If you have a special backing with borders or other design elements, we will do our best to center it, however, it may not end up perfectly centered due to changes in the fabric during the quilting process.
Top and back are pressed and stray threads are removed
Please carefully press your quilt top and backing, pressing seams flat, and removing any stray threads.
Tops of the quilt and back are marked
If you have a directional print or preference, please indicate the top of the backing and the top of the quilt top by pinning a note to each.
All seams are secure, appliques are stitched down
Double check your quilt to and backing to be sure that all seams are completely sewn and appliques are completely attached at the edge of the applique. This hellps to prevent the quilting foot from catching and damaging a seam or applique as it stitches over the area.
Bias and pieced edges of quilt top are stay-stitched
If edges of the top are pieced or are on the bias, stay-stitch (using a stitch length of 2.0 or less) 1/8" from the edge of the top (be very careful not to stretch the edges).
Special areas of the quilt top are marked
If you have a pocket, or a fabric photo that you don't want us to stitch over, please mark the area with a note pinned to the quilt. Likewise, if there is an area on the quilt that would not react favorably to a hot iron or a spritz of water, please mark the area with a note pinned to the quilt top.
Embellishments are removed
The longarm quilting machine cannot stitch over embellishments like beads, buttons, or stuffed applique. Please wait to attach these until after the quilting process.
Backing measures at least 8" longer and 8" wider than the quilt top
Please be sure that the backing measures at least 8" longer and 8" wider than the quilt top - that equates to 4" extra on all 4 sides. This amount is necessary to attach the quilt backing to the quilting frame an to hold it taut during the quilting process.
Backing is squared up and edges trimmed to a rectangle or square
Square up the backing and trim the edges if necessary so that you have a rectangle or square with no uneven edges. We attach the edges of your backing to the quilting frame, if the backing is not "square" there will be slack areas in your backing resulting in wrinkles or tucks quilted into the final product. If you piece your backing, please remove the selvage edge from the seam and use a 1/2" wide seam allowance. Press the seam open. Use a horizontal seam if at all possible. It is fine to leave the selvages on the outer edges of the backing
Stiff or flannel backings are pre-washed, minky backings have been de-fluffed
Fabrics with a hard finish should be pre-washed to soften them for needling. Flannel backings should be pre-washed since some of them shrink more dramatically than quilting cotton. Either toss your minky backing into the dryer to help remove the lint from the cut edges, or roll them with a lint roller.
Backing is NOT a digital print
No digital prints on the back of the quilt - these fabrics will work on the top of a quilt, but do not needle well on the back.
Batting measures at least 8" longer and 8" wider than the quilt top
Please be sure that the batting (if you provide it) measures at least 8" longer and 8" wider than the quilt top - that equates to 4" extra on all 4 sides. We do not accept pieced batting.